How to fix my MacBook if it won’t turn on? – Causes and Effective Solution

As advantageous as it may seem to you MackBook vs. Chromebook, these after a certain time begins to present faults and inconveniences with its ignition. As such, it would be impossible to tell you for sure what the problem is causing it.

Therefore, when a Macbook does not turn on, the best thing to do is to verify what the causes are and then implement the corresponding solution.

What is the reason my MacBook can’t turn on?

The causes can range from something as simple as your laptop battery not having a charge, to having a hardware problem that, in general, the ignition is associated with components like the motherboard, RAM, the video card you have installed or the hard drive.

In general, what is recommended for this problem is to reset the Frimewok when it comes to a problem at the Software level. On the other hand, users are advised to verify the integrity of each of the components. Of course, this as long as you know how to do it, since these devices are delicate when handled.

Something very simple you can do if by chance you turn on your Chromebook but it still has problems, it is to avoid suspending the hard drive. You could say that this is a way to detect that the problem lies with the hard drive of your computer and not with another component.

How can you force power on your MacBook?

Before deciding whether to take your computer to technical support or go with an unofficial technical specialist, you can implement some steps that can help you come up with a solution. Keep in mind that what we will mention below will not be 100% effective solutions, but they will help you to a great extent.

Check battery status

The first step is to try turn on the equipment and verify that the fan hard drive is not making strange sounds. To achieve this, you have to press on the power button and keep an eye on the caps lock key to see if there is any change. Anyway, you can learn how to partition a hard drive without formatting it, maybe it can help you.

Check the power signals

This is linked to the above mentioned. Keep in mind that you should not only check the power signals of your equipment, but also the charger and/or the outlet where you connect your equipment. It will seem obvious, but it happens a lot that electrical connection points they do not have power or the necessary contact is not being made.

Do a power cycle

The energy cycle will allow you to give it the calibration that the battery of your Macbook needs to. Of course, to do this check, you need to be able to turn on and use the laptop.

The idea in essence is that you charge the equipment and use it until it runs out of charge. Once the equipment is downloaded, you wait about an hour and then you put the equipment on charge without turning it on. Once the charge is finished, the battery should be calibrated.

Look at your Mac’s hardware

This is what we discussed in previous paragraphs, it is about verifying each of the components. If possible, change each of the components, in this way you can identify if any of the components has faults or else.

In case you don’t find anything doing this, chances are a smaller component has burned out or isn’t doing anything. proper contact with motherboard. Component tests may require you to force your Mac to shut down

Reset the controller (SMC)

The SMC is a chip that is responsible for managing the system. this component It is located on the motherboard of your computer. In certain cases this presents a problem regarding the management of the board with the other components. So to get the SMC controller reset:

1. Make sure the device is turned off
2. now remove the battery
3. Hold down the power button for 5 seconds and then install the battery again.
4. Now press again the power button and ready, this should be enough to reset the controller.